Fascia boards are basically the trim boards that are attached to each end of the roof drip edge. The roofs of houses have sloping edges and these boards are very beneficial for covering all the ends and edges of the rakes of the sloping edges of the roof of your home.

The fascia boards installed in your home can go bad with the passage of time due to getting in touch with water constantly.

Many people do not often find out about this problem and they do not resolve it as well full stop the reason behind this problem is that the fascia boards have not been painted earlier to provide the maximum amount of security.

If the roofline of the house is extremely high then replacing the fascia wood under your garage gutter is going to be a tough job for you.

You are going to require some experienced and skilled carpentry workers to do this job for you in an efficient manner full. Without any doubt in your mind, you can easily choose Taylor fascia for this job to be done in your home with appropriate security.

In this article, we are going to discuss how you can replace the fascia wood under garage gutters.

So, keep on reading to find out more information below about Taylor fascia.

 1. Step One:

 The first and most important thing is to find the right side of the ladder that is going to allow you to reach the gutters and fascia boards appropriately. Always remember that the ease of access is the most important thing when you are about to do this job!

 2. Step Two:

 The next step is that you need to replace the gutters from the fascia board. For this, you will have to remove the long nails by using a hammer or a pry bar.

 3. Step Three:

 Now you will have to measure the size of the already placed fascia boards by using a measuring tape. Make sure that you’re all the edges and sides properly before you go out and purchase the new boards.

 4. Step Four:

 The next thing that you need to do is to remove the old fascia board and make sure that you are not damaging your roof and its edges. If the drip edge is extremely tight then it is going to be a tough task for you to perform. That is the reason why it is better to hire a professional to do this job for you with maximum protection. You can use a hammer to remove the remaining nails as well.

 5. Step 5:

 Now you need to my all the coronavirus. If you have got 8 feet pieces of the board then you have to measure it to the nearest 8-foot mark as well.

 6. Step 6:

 Now you can put your new fascia board up with the help of Nails and screws. After this, you need to apply to call King 2 you the same and the nails on the screw holes.